|Case depth||17 mm|
|Strap type||Stainless steel (fits wrist of about 14-23 cm in circumference)|
|Strap width||22 mm|
|Water resistance||100 atm (diving)|
|Clasp Type||Deployment clasp|
|Case material||Stainless steel|
|Color of dial||Green|
|Link type on strap||Pin Links|
This has an NH35A automatic clockwork, which has 24 jewels and up to 41 hours of power reserve.
This watch's pointers are coated with Super Luminova pigment (not radioactive), that gives up to 10 times more effect than conventional pigmentation.
This watch is equipped with a rotating bezel, which can be used to mark the beginning/ end of a time interval.
Prevents penetration of water. To set the watch, the crown must first be screwed up.
This watch is equipped with a helium valve, which equalizes air pressure while you are diving, to prevent damage to the watch.
The date is shown on the display.
Stainless steel bracelet
Tough, durable and elegant; a bracelet made of stainless steel gives the watch a classic quality look.
Sapphire is up to 7 times harder than steel, and surpassed only by diamonds on the Mohs scale. This makes sapphire glass a great protection for your watch.
This watch automatically charges from the energy caused by your movement. If the battery is emptied, it only needs a few seconds of movement/energy to start working again.
Water protection: 1000 meter (100 bar)
This watch can be worn while diving. The value refers to the pressure in water, at that depth, while motionless... and should not be seen as the depth for wearing the watch..
Condensation - important!
Rapid changes in temperature can cause condensation inside the watch. If you notice moisture beneath the glass, you should immediately go to a watchmaker, who can open and dry the watch. Even if the signs of moisture disappears, by themselves... the moisture will not - and will eventually damage your watch - so, visit a professional and remove it permanently. Even waterproof watches are not protected against condensation, so keep that in mind if you plan to go from very hot to very cold temperatures - like from a hot sauna directly to the snow. If condensation occurs, it very rarely (if ever) depends on manufacturing, so if your watch is damaged by moisture, warranty will probably not cover it (it could be manufacturing issues, but... most likely it will be because of the rapid change of temperature = natural causes).
This watch has a width of 44 mm (the dial, measured from left to right, with the crown excluded). Even if some watches are not perfectly circle shaped, we still use the term: diameter - and we only measure the case, completely ignoring the crown (even though some includes it, in their measurements).
Case made of stainless steel.
Does this watch fit your wrist? Wristwatches has gradually become larger in size, and a typical men's watch is usually between 40 and 45 mm wide. If you have a wrist that is noticeable larger/smaller, we recommend that you focus on the sizes in/outside the outer edges of the typical sizes. You are always welcome to contact our support, so we can share our experience with you.
This watch has an extra safety mechanism, which prevents the lock from getting opened by accident.
We are an official reseller of all brand's watches that we sell. That equals to: genuine watches with valid warranty and access to official service.
This product description is created specifically for Watchia.com and may not be copied (in whole or in parts)! Violation will therefore be met by demands of compensation.
OceanX Sharkmaster 1000 Meters Automatic Diver SMS1083 er 44 mm bredt over urkassen (fra venstre til højre). Tykkelsen er 17 mm.
For bedre at kunne forstå størrelsen på dette ur, har vi sammenlignet det med en dansk 5-krone. Billedet til venstre viser hvor meget af uret der dækkes af 5-krone mønten (som er 28,5 millimeter i diameter). Hvis du ønsker at se en oversigt over flere størrelser sammenlignet med en 5-krone mønt, så finder du den her
Hvordan måles urets størrelse?
Vi bruger udtrykket diameteren, men da ikke alle ure har cirkelformet urkasser, så er dia meteren reelt bredden målt fra venstre til højre. Bemærk at enkelte producenter inkluderer kronen (til at indstille uret) og knapperne når de måler bredden, men vi forsøger at standardisere alle urene ved ikke at medregne kronen som en del af bredden..
Tykkelsen - eller højden på uret i profil - angives ved at måle uret fra top til bund som illustreret nedenunder. Til sammenligning er en 5-krone mønt 2 millimeter tyk.
Man definerer normalt urene ud fra disse tal::
Tynd: 4-6 millimeter
Normal: 6-12 millimeter
Stort: 12-14 millimeter
Oversize: 14-18 millimeter